Step-by-Step Guide

Step 1

Step1

Shampoo and condition your hair with a good conditioner.

Allow to dry completely.

Step 2

Brush the hair for a few minutes using either a brush or a wide toothed comb.

Select the area to be thickened and lift upwards, holding in position.

Step 3

Shake the can well. Spray the thickener across the base of the thinning hair as shown in the video until sufficient coverage is achieved. Allow to dry and then seal with Mane Seal and Control.

Repeat the process for all areas of the hair that are to be thickened.

Step 4

Once the hair is completely dry, style as desired. Feel free to brush your hair or use your usual styling products.

Step 5

As a finishing touch add a light coat of either Mane Seal and Control or Mane Seal and Shine. Allow to dry.

General Tips

Always follow the step by step instructions.

Mane Hair Thickener should be sprayed from a distance of approximately 15 - 20cm (6-9 inches) from the head to help achieve consistent coverage.

Mane products are not hair baldness products but thinning hair products

Understand each step before you proceed to the next.
Once applied, all your previously this areas will be thickened.
You will be able to have hairstyles denied to you in the past.
You can participate in sports.
After swimming, allow hair to dry naturally without vigorous rubbing with a towel.

Can blockages

Sometimes the can nozzle can become blocked. This is normally caused by the fact that the last time the can was in use it was sprayed in short bursts as oppose to long sprays.

To prevent your can becoming blocked, after you have finished using it, please fully depress the actuator/nozzle for 2 seconds before storing away.

A blocked nozzle cannot be unblocked.

Should you experience such a problem, please phone us on 0044 (0) 207 631 3860 or email us at : maneuk@aol.com.